Wooden floors are very much in trend and typically last for the life of a home, but they may lost that original shine and need refinishing. Refinishing can clean those floors dirty from years but only floor sanding and polishing in Melbourne can bring back the luster. If your floors are too dirty and in bad shape, you can easily sand them back to their original state. But this entire process require you to be very careful.To get learn more about the Gettysburg Floor Sanding and Refinishing.
Here we will discuss some steps of sanding and polishing and things you should keep in mind. Let’s get started:-
-Remove the Old Finish – Check the entire surface very carefully and if there are any raised corners or nails, holes, nicks or dents, remove them properly. Clean if there is any sticky material as this may ruin the entire sanding and polishing process. The surface must be properly cleaned before starting and get all furnishings removed too.
-Use Portable Edge Sander – You can hire floor sanding equipments or get the entire work done through professionals. If you are doing it yourself, make sure to use portable sander as it will work better in the required perimeter. Before starting, ask professionals to demonstrate how to operate machines and how to install sanding belts.
-Cover the Openings – Before starting the process, cover all the openings like electrical switches, outlets, and heating ducts. Use tapes and heavy plastic to cover all these things and it’s better to drop sheets on the door itself. Take out all furniture, curtains, carpeting, rugs and window shades as it will be easier to work in an empty room.
-Start with Rough Sanding – Start from one corner of the room and sand diagonally using 24 grit sand paper and this will help you properly sand the edges or joints of the floor planks. Keep the windows open for ventilation while you use machines. Make sure that the sandpaper belt is not in contact with the floor while turning on the machine. The sandpaper belt should make contact with the floor when you slowly push the machine forward.
-Start with Medium and Fine Sanding – Once you have sanded the floors using 40 grit sandpaper, load the machine with 80 grit to repeat the same procedure. First, cover the main area of the room and then the borders. Once finished with medium sanding, clean and vacuum up all the dust. For fine sanding, use 100-120 grit sandpaper and make your surfaces silky smooth.
-Start with Polishing – Once the entire sanding process is done, it’s time to give a smooth and shiny finish to the floors. Polishing is like a mask that keeps the surface safe from wear and tear. You can choose from a variety of finishes, but make sure it blends properly with your existing floor texture and color.